Lancia Beta Coupe and Spider scheme
Drawing | Hole | Location | Tube number | Notes |
Treatment at floor | ||||
- | - | Engine compartment lid | 1 | Remove plug, Pull covering away |
A 1 | Front cross member | 1 | ||
A 2 | Front mudguards, front section | 1 | ||
B 3 | Front mudguards | 1 | Remove inner mudguard | |
B 4 | Reinforcement in front mudguards, front section | 1 | Spray from engine compartment | |
C 5 | Reinforcement in front mudguards, rear section | 1 | ||
C 6 | Torpedo | 1 | Close air vents C6 and D6 | |
D 7 | Front door post | 1 | Remove plug or socket | |
D 8 | Doors, front section | 3+1 | Remove plug | |
E 9 | / | Doors | 3+4 | Remove reflector |
F 10 | Side panels | 1 | Remove plug | |
G 11 | Rear side panels | 1 | ||
G 12 | Rear valances | 1 | Remove luggage compartment floor sheet | |
G 13 | Rear cross member | 1 | Lift covering | |
G 14 | Rear panel (Coupe) | 1 | Remove covering | |
G 15 | Rear panel reinforcement (Coupe) | 1 | Remove covering | |
G 16 | Rear panel (Spider) | 1 | Remove covering | |
G 17 | Rear panel reinforcement (Spider) | 1 | Remove covering | |
Treatment at lift | ||||
H 18 | Forward cross member | 1 | ||
H 19 | Forward side rails | 6 or1 | ||
H 20 | Subframe | 1 | ||
H 21 | Cross reinforcement | 6 | Remove plugs | |
H 22 | Tunnel reinforcement | 1 | Remove large plug. Do not spray upwards | |
H 23 | side rails | 5 or 6 | Remove plugs | |
H 24 | Valances under doors | 6 | Remove plug | |
H 25 | Jack mount | 1 | Coupe only | |
H 26 | Rear side rails | 6 | Remove plug. Forward spray |
See general instructions for symbols etc..
Last update 22.2.2006